Bosch KTS340 Diagnostic Tester - Connections |
Mobile power supply and mains connection

Connections: USB for PC and printer, card slot and mains operation
Can be used everywhere for around two hours with an alternative supply from two internal commercially rechargeable
batteries (AA cells NiMh). Supply also during diagnostics via the OBD cable. Mains connection:
Port jack for power supply unit and charging contacts for supply via charging tray.

Multimeter function: Ideal in the test procedure

For fast measurements: Multimeter
Connections in channel 1: Socket yellow (+) and blue (-), channel 2: Socket red (+) and black (ground). CAS[plus] also makes the multimeter function available directly on the troubleshooting
interface: Resistance, current and voltage values with automatic target-actual comparison. The
measured values can also be displayed as curves.

Wireless and mobile

WLAN: Always connected
About WLAN (in preparation), e.g., protocols and
maintenance plans can be printed out wirelessly
via PC.

Adapter: Equipped for the future

The adapter is located on the rear side of the housing
The current adapter is integrated in the housing. Fast updating is possible at any time following changes to vehicle interfaces. The OBD adapter is the same as with the radio modules of the KTS 5 series.
|